Unite
®
Panel System - Worksurface with Gallery Panel Installation
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
23
Gallery Panel Worksurface
Edge Support Bracket
Installation
Worksurfaces can be used with all
gallery panels. Slots for cantilevers
on the Unite panel frame with gallery
panels installed are exposed the
same as Unite panels and returns.
Overheads can be used with similar
rules as Unite panel loading.
Note:
When more than one
worksurface is used between two
gallery panels, a worksurface edge
support bracket must be installed to
each gallery panel.
1. Position the worksurface
edge support bracket under
worksurface as illustrated and so
it is not exposed. The side with
the holes must go against the
gallery panel and the non-hole
side will face the underside of the
worksurface (Figure 29).
Note:
No pre-drilled holes are on
the gallery panel for worksurface
edge support brackets.
2. Using the supplied #12 x 1”
screws, attach the edge support
bracket into the gallery panel,
making sure it is tight to the
underside of the worksuface and
not exposed to the user side
(Figure 29).
