Unite
®
Panel System - Worksurface Installation
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
13
Peninsula & Conference End
Worksurfaces
Peninsula and conference end
worksurfaces are installed to
the Unite Panel System with
approved brackets on one end
and utilize either a worksurface
support leg or a set of post legs
as support at the outside end of
the worksurface. Space-planning
layout will outline the components
to be used.
1. Carefully turn the peninsula or
conference end worksurface
upside down onto a soft,
protective surface. Determine
which end of the worksurface to
install either a pair of post legs or
a worksurface support leg. If post
legs are used, follow step 2 below
then skip to step 4, next page. If a
support leg is used, skip now to
step 3, then continue on to
step 4, next page.
2. Position both post legs onto the
underside of the worksurface,
square to the corner with the edge
of the mounting flanges spaced
2
1
/
4
” from the outside edges of
the worksurface as illustrated.
Using the mounting flanges as
a template, carefully drill four
1
/
8
” diameter holes to no more
than
1
/
2
” deep into underside
of worksurface at both post leg
mounting brackets. Take care to
not drill too deep or damage to
the surface may occur. Secure
each post leg to the underside of
the worksurface using four
#12 x
3
/
4
” screws. Take care to not
over-tighten the screws
(Figure 16).
3. Position a worksurface support
leg onto the underside of the
worksurface, centered and flush
with the end and over pre-drilled
mounting holes. Secure to the
underside of the worksurface
using six #12 x
3
/
4
” screws.
Take care to not over-tighten the
screws (Figure 17).
Caution:
Non-panel supporting
worksurface support legs cannot
be use to make stand-alone
tables because the leg does not
contain the “racking” stability
required.
#12 x /
3
4
”
screws
2 / ”
1
4
2 / ”
1
4
#12 x /
3
4
”
screws
#12 x /
3
4
”
screws
2 / ”
1
4
2 / ”
1
4
#12 x /
3
4
”
screws
