22
Unite
®
Panel System - Worksurface with Pedestal Support Installation
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
#12 x /
3
4
”
screws
#14 x /
7
8
”
screw
Deep Worksurface Connections
with 74P Edge” instructions on
page 5 for splice plate installation
(Figure 28).
6. Re-install pedestal drawers by
first extending suspension out
of the cabinet. Slide the rear slip
connection together by aligning
the tab of the suspension with
the corresponding slot in the
drawer body. Hold suspension
firmly while pushing the drawer,
making sure the slip connection is
together properly.
8. With the rear slip connection
in place correctly, the front
connection tabs will align and the
drawer can be pushed down and
snapped securely into place.
the front and side of the pedestal
is flush with the edges of the
worksuface as illustrated
(Figure 28).
Note:
If a Knife Edge worksurface
is being installed, the pedestal
will be set back 2” from the front
edge of worksurface.
4. Once aligned, secure pedestal to
underside or worksurface using
four #14 x
7
/
8
” screws through the
pre-drilled holes on each corner
of the pedestal (Figure 28).
5. To keep worksurfaces level,
install a small splice plate
between adjacent worksurfaces as
illustrated. Perpendicular 24”-30”
Note:
If installing a double
pedestal (not shown), no holes
have been pre-drilled into the
underside of the peninsula
worksurface for installation.
Once the double pedestal
is aligned square, use the
pedestal mounting holes as a
template, and pre-drill using
a
1
/
8
” drill bit to a depth of
1
/
2
”
into underside of worksurface.
Take care to not drill too deep.
3. To attach the pedestal to the
underside of the worksurface,
first align the mounting holes
of the pedestal to the
pre-drilled mounting holes of
the rectilinear worksurface.
Next, adjust glides on
the pedestal to level the
worksurface and check that
Typical Rectilinear Worksurface
with Adjacent Worksurface and
Pedestal Support Installation
1. Carefully place worksurface onto
installed cantilever bracket, panel-
mounted support leg and pedestal
then align worksurface to adjacent
worksurface as illustrated. Adjust
glides under the pedestal to level
the rectilinear worksurface. Using
the cantilever bracket and support
leg mounting holes as a template,
pre-drill required mounting holes
to
1
/
8
” diameter and
1
/
2
” deep into
the underside of the peninsula
surface. Take care to not drill too
deep (Figure 28).
2. Using #12 x
3
/
4
” screws provided,
secure the bracket and support leg
to the rectilinear worksurface. Take
care not to over tighten screws
(Figure 28).
