16
Unite
®
Panel System - Worksurface Installation
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
#12 x /
3
4
”
screws
#12 x /
3
4
”
screws
panel-mounted
support leg
(left-hand)
panel-mounted
support leg
(right-hand)
center
panel-mounted
support leg
Worksurfaces to Panel-
Mounted Support Legs (cont.)
Important:
Right- and left-
hand support legs install to
the panel slotting of the same
panel as the worksurface. Center
panel-mounted support legs
are installed such that the teeth
engage the panel that is opposite
the side with lock bracket nuts,
thus centering the center support
leg at the seam between panels
(Figure 19).
Note:
It is important to install
all panel-mounted support legs
at the same time, including any
required at the opposite side of
the panel wall. Support leg glide
adjustment and securing of lock
brackets must be done only after
all panel-mounted support legs
are installed.
Note:
Standard 2"
height-adjustable glides ship
installed in support legs. If more
leveling height is required, 3
1
/
2
"
glides are available by contacting
KI Customer Service.
4. With all teeth of the support leg
set into the notches of the panel,
and all support legs installed,
adjust the glides downward to
raise the leg and engage the
upward facing teeth. Then grip
both studs of the lock bracket and
slide the lock bracket down until
the teeth are fully seated against
the panel slot faces. Ensure that
both the upward facing stationary
teeth and the downward facing
lock bracket teeth are tight against
the slot faces in both the up and
down directions. Tighten the lock
bracket nuts to secure the support
leg to the panel (Figure 19,
Details D & E).
5. Adjust all glides so support leg
tops are level front to back prior
to installing worksurfaces
(Figure 20).
6. Set worksurfaces onto
panel-mounted support leg pairs
one at a time. Align pre-drilled
holes at underside of worksurface
with mounting holes of support
legs and secure with #12 x
3
/
4
”
screws. Use six screws at each
support leg and take care to not
over-tighten screws (Figure 20).
