14
Unite
®
Panel System - Worksurface Installation
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
#12 x /
3
4
”
screws
#12 x /
3
4
”
screws
adjoining worksurface
(18 depth)
”
Peninsula & Conference End
Worksurfaces (cont.)
4. Carefully turn the peninsula or
conference end worksurface
right-side up next to the adjoining
worksurface and position the
panel-mount end onto the
mounting brackets installed to
the panel (edge support bracket
and design bracket illustrated).
Align the pre-drilled holes in the
underside of the worksurface
with the mounting holes in the
brackets and secure using
#12 x
3
/
4
” screws. Take care to
not over-tighten mounting screws
(Figure 18).
5. Position a small splice plate
under both the peninsula/
conference end worksurface and
the adjoining worksurface as
illustrated. Align small spice plate
to pre-drilled mounting holes
under both worksurfaces and
secure using two #12 x
3
/
4
”
screws per worksurface
underside. Take care to not
over-tighten screws (Figure 18).