Keysight U2741A, Руководство программиста

Страница: 90 / 169

6 SENSe Subsystem
90 Keysight U2741A Programmer’s Reference Guide
[SENSe:]FRESistance:RANGe
Syntax
[SENSe:]FRESistance:RANGe <range|MIN|MAX|AUTO>
This command sets the measurement range for four-wire resistance
measurements.
[SENSe:]FRESistance:RANGe?
This command queries the measurement range for four-wire resistance
measurements.
Parameter
Remarks
– Selecting a fixed range will disable autorange.
– If the input signal is greater than can be measured on the selected range
(manual range), the U2741A gives an overload indication of
+9.9E+37
from
the remote interface.
– The U2741A is set to 1 k Ω , with autorange enabled, after a factory reset (
*RST
command).
Examples
FRES:RANG 100
//Configures the U2741A to measure
resistance at 100
Ω
range
FRES:RANG?
//Queries the resistance range
Typical Response:
+1.02
See Also
CONFigure:FRESistance
[SENSe:]FRESistance:RANGe:AUTO
Item Type Range of values Default value
range Numeric 100 Ω , 1 k Ω , 10 k Ω , 100 k Ω , 1 M Ω , 10 M Ω , 100 M Ω
MIN = 100
Ω
MAX = 100 M Ω
1 k Ω