Keysight M9521A, Руководство для стартапов

Страница: 13 / 38

Keysight M9521A AXIe System Module Startup Guide 13
Step 3: Install the AXIe System Module in the Chassis
Step 3: Install the AXIe System Module in the Chassis
Before powering on the chassis, install the AXIe System Module (ASM) in the
AXIe chassis.
1 Make certain the AXIe chassis is not powered on.
2 Locate the top and bottom guide rails for the ASM slot (Slot 7 in the M9514A
chassis).
3 Align the ASM’s circuit board with the chassis guide rails. Slide the ASM
gently into the two rails. If the fit is tight, slide the ASM back out and recheck
alignment.
4 Locate the insertion/extraction handles at each side of the ASM’s front panel.
Extend the ends of both handles, by pulling them inwards towards each other;
the plastic handle end slides about 1 cm on the metal handle shaft. Then fully
open the handles by pivoting them out towards you until they are
perpendicular to the front panel. The left handle is shown below, from the top
view, correctly extended.
5 Slide the ASM completely into the chassis. When the module’s backplane
connectors contact the chassis backplane, you will feel resistance and the
two handles will begin to close toward each other. The module’s faceplate will
be about 1 cm from the chassis front panel.
6 Continue nudging the ASM faceplate gently but firmly with your thumbs, until
the handles are pressed up against the chassis and the module’s front panel
lies flush with the chassis’ front panel. This seats the module firmly in the
chassis backplane. If necessary, gently press inward (toward the chassis) on
the handles to ensure full insertion.
7 Tighten the captive retaining screws at both top and bottom of the ASM.
Modules are grounded through the chassis. Tighten the module
retaining screws to ensure a proper ground connection.