Keysight Technologies M9506A-BC1, Инструкция по эксплуатации, Страница: 27 / 96

M9506A-BC1 5-Slot AXIe Chassis with Integrated Controller User Guide 27
Chassis Installation 2
3
Align the module’s circuit board with the guide rails on both ends of the
chassis. If the module has metal plates covering the circuit board, be sure to
insert the circuit board and not the metal plates into the rails. Slide the board
gently into the two rails. If the fit is tight, slide the board back out and recheck
alignment.
4
Locate the insertion/extraction handles at each side of the module’s front
panel. Extend the ends of both handles, by pulling them inwards towards each
other; the plastic handle end slides about 1 cm on the metal handle shaft. Then
fully open the handles by pivoting them out towards you until they are
perpendicular to the front panel. The left handle is shown below, from the top
view, correctly extended.
If either handle is misaligned, you will not be able to properly install the
module.
5
Slide the module completely into the chassis. When the module’s backplane
connectors contact the chassis backplane, you will feel resistance and the two
handles will begin to close toward each other. The module’s faceplate will be
about 1 cm from the chassis front panel.
6
Continue nudging the module faceplate gently but firmly with your thumbs,
until the handles are pressed up against the chassis and the module’s front
panel lies flush with the chassis’ front panel. This seats the module firmly in the
chassis backplane. If necessary, gently press inward (toward the chassis) on the
handles to ensure full insertion.