16
1.23 Increasing the temperature of the boiler
– this parameter allows you to
adjust the characteristics of a weather cycle 1 to cycle 2.
1.24 Heating circuit 2
– This parameter enables the activation and operation mode
selection circuit 2.
YES
– 2 circuit activates.
AUTO
– 2 circuit is switched on after passing the controller in operation mode
WINTER.
6. Setting the parameters – service mode.
Service parameters are divided into groups. For each group are assigned
service parameters possible to change. Entry into service mode after press
and hold for about 3 seconds the MENU button. regulator displays a list of
service parameters possible to edit and change.
Viewing the list of parameters is possible by turning the multifunction knob -
possible to edit the parameter is highlighted. After selecting the desired
parameter press the OK button (knob), and enter the subgroups of a given
parameter. Select the parameter you want to change and press the knob -
a parameter is highlighted. Turning the knob set the desired value and then
press the knob. Giving up mode changes and restore the previous value of
the parameter by pressing the STOP button or ESC. If the unit is left in
a mode change or view the parameters for 60 seconds, the controller will
automatically withdraw the recently introduced modification and switch to
display the status of the device. A list of all service parameters presented in
the table. The table columns contain the following order: group number,
name of the parameter and the value of the minimum and maximum
possible settings.
