Kettler SG2R, Инструкция по обучению и эксплуатации

Страница: 21 / 72

Selecting Language
When putting into operation for the first time or after an upda-
te of the operational software (firmware), the menu for langua-
ge selection will be displayed.
Use navigation keys “ Up ” and “Down” to select language.
Press “Selection” to accept language selection and to open
the “Display” menu.
Press “Cancel” to get back to the main menu. Settings will not
be saved, display will be shown when switched on again.
Display Settings
After selecting the language, the menu for setting the LCD’s
brightness and contrast will be displayed.
Press “Back” to get back to the main menu. The settings will
be saved.
Press “Cancel” to get back to the main menu instantly.
Settings will not be saved, display will be shown when swit-
ched on again.
When the optimal contrast is set, there will be no heavy sha-
des. The setting “Contrast” applies to the lower display and
“Brightness” to both displays.
Note:
Short description
The electronic unit consists of function keys and a display.
Display area / Display
Function keys
By means of these 4 keys, you can activate functions, which
are then shown in the above display, e.g. Back, Menu etc. The
functions of the keys may vary from one menu to the other.
Navigation keys
Use the navigation keys to select menu features
or menu entry fields.
Enter keys minus - / plus +
By means of these keys, you can alter values, adjust the stress
values for training and shift profiles.
• “Plus” increases the values or alters settings
• “Minus” reduces the values or alters settings
• Press “Plus” or “Minus” for a
longer
period of time > quick
modification
• Press “Plus” and “Minus” at the same time:
• Stress skips to
smallest performance
• Programmes skips to default setting
• Value input skips to Off
Resetting the Display (Software-Reset)
Pressing the three keys at the same
time, will restart the equipment.
Radio remote control
The keys of the radio remote control have the following func-
tions:
Type of pulse taking
The pulse will be taken by means of a receiver located behind
the display and the Polar chest belt T34 included in the scope
of delivery.
Appliance interface
The USB to PC interface is located on the side, close
to the equipment control switch.
3
GB
SG2R
+
Increase level
Decrease level
During training only:
change of display
During training only:
Change of performance display