Ketterer Drive System 3062, Руководство по сборке

Страница: 32 / 35

Operation
3062.72-01 Rev. A
S e i t e | 29
7.1 Operation with a wind sensor
Instructions for operation with a wind sensor:
If you need a wind sensor for your application, e.g. for umbrellas
or other shading systems such as a pergola, observe the
following instructions.

The wind sensor serves only as a support; in the event of rising
wind, the operator must take responsibility for adequately
securing the application against personal injury and damage to
material.

In the event of rapidly arising wind, such as individual gusts,
whirlwinds or similar, in many cases the application cannot be
secured quickly enough by the drive system before wind
damage occurs. Depending on the application, the securing
process can take several minutes. The operator must therefore
observe the following safety instructions:
- The application must always be observed when wind is a
threat. The operator must check the wind strength before
operating the drive system.
- In the event of an arising wind, the operator must
immediately secure the application using the radio remote
control and not wait for the signal from the wind sensor. If
motorized securing is not possible (e.g. due to blocking
time), the operator must be able to fall back on a suitable
system.
- The wind sensor may only be used if there are no objects
such as tables or persons in the danger zone of the
application.
- Ketterer accepts no liability for damage to persons or
material and consequential damage caused by wind, even
when a wind sensor is used.
The radio module of the drive system offers the possibility
to teach-in 2 sensors (dusk/dawn) and/or wind sensor. The
sensors from Geiger Antriebstechnik are suitable. Please
contact the manufacturer for this purpose.