Ketterer Drive System 3062, Руководство по сборке

Страница: 20 / 35

Assembly
3062.72-01 Rev. A
S e i t e | 17

Grease the entire length of the spindle with 60 grams
Castrol Optitemp LG2

The spindle is mounted with the enclosed screw DIN912-M8x40
and nut DIN985-M8-VZ via the bore provided in the output
shaft, see Figure 5-1.

Make sure that the tightening torque is 18 Nm ±2Nm.
Figure 5-1: Connection of a spindle
5.3 Mounting the drive system in your application
 Fasten the drive system using the mounting points provided on
both sides in the housing and motor adapter, see Figure 5-2 and
Figure 5-3. If the drive system is only fixed on the housing and
not on the motor adapter, the motor can rotate freely and the
function in the application may be restricted.
 The length of the screws depends on the mounting position in
the application and must be selected by taking the specified
thread length into account. The screw-in depth should be at
least 8 mm for M6 screws.
 Fasten the spindle nut to the screw connection points provided
for this purpose.
 Only use screws which are suitable for the forces occurring in
the application and for all tensile and compressive forces.
 Make sure that the selected screws are tightened with a correct
torque value. Check that the screws are firmly seated. Use
appropriate tools to tighten the screws to ensure a secure seat
and to avoid damage to the screws.
 If there is no protection against moving parts or heated housing
parts of the drive system, the system must be mounted at a
height of at least 2.5 m above floor level.
 The drive system must not sit directly on the ground, but must
be positioned at least 10cm above ground level.
 The drive system must be protected against intrusion of
moisture.