Ketterer Drive System 3062, Руководство по сборке

Страница: 26 / 35

Start-up
3062.72-01 Rev. A
S e i t e | 23
CAUTION!
Danger due to hot surfaces.
The surfaces of the drive system and surrounding components can,
depending on the load and the ambient temperature, exhibit
temperatures above 90 °C during start-up and can lead to burning.
►
Touching the components of the drive system during start-up is
only permitted after complete cooling and with personal
protective equipment. Wait at least 45 minutes after the last
motor activity.
Preparatory activities:
 Be sure to connect all PE protective conductors and ground
conductors before initial start-up and make sure that the RCD
circuit breaker and fuse are functional.
 Before start-up, have the electrical equipment checked by a
qualified electrician in accordance with the standards and
regulations applicable in the country of use.
 Check for correct mechanical assembly.
 Make sure that the spindle has been sufficiently greased.
6.1 Teaching-in / deleting a radio remote control
Up to 3 radio hand-held transmitters and additionally 2 sensors
(e.g. dawn/dusk or wind sensor for shading applications) can be
taught-in per motor.
CAUTION! Disconnect all other drive systems in the proximity from the power supply.
Otherwise, these may also take over the radio remote control to be taught in.
Definition of "close range":

Hold the remote control directly to the motor control, maximum
distance 15cm. Alternatively, hold the radio remote control to
the motor cable, which serves as an antenna up to a length of 3
meters.