KEP Multi-Protocol Communication Card Option Start-up Guide
Page 8
3 SETUP FOR COM CARD
3.1 Record Identification Data
3.2 Point Count Capacity and Registers per Device
Each unit has a unique part number located on the side or the back of the unit. This number
should be recorded, as it may be required for technical support.
Record Your Model Number Below: Example:
ST2 O 1 3 BAC/IP P
MODEL NO. __________________________________________________________________
•
Option 3 units have the following 2 ports: Et RS-485
•
Option 4 units have the following 2 ports: Lo Ethernet
The total number of Registers presented by the device attached to the COM CARD cannot
exceed:
Model
Protocols Supported
Option 3 (Specify Protocol) BACnet IP, BACnet MS/TP, Modbus TCP/IP, Meyasys
N2, AB DF1, AB Ethernet/IP
Option 4 (LonWorks)
LonWorks
COM CARD Option Part Numbers
Part number
Total Registers
Option 3
1,500
Option 4
1,500
Figure 2: Supported Point Count Capacity
Devices
Registers Per Device
SUPERtrol_II
116
SUPERtrol_I
64
LEVELtrol_II
40
ES762-ST2
126
Figure 3: Registers per Device
