KEP Multi-Protocol Communication Card Option Start-up Guide
Page 3
Quick Start Guide
1. Record the information about the unit. (
Section
3.1
)
2. Set the device’s Modbus RTU serial settings (i.e. baud rate, parity, stop bits) and Modbus
Node-ID for the device connected to the COM CARD. (
Section
3.3
)
3. Metasys N2 or Modbus TCP/IP: Set the Node-ID. (
Section
3.3.2
)
4.
Connect COM CARD
4 pin RS-485 port to the Field Protocol cabling, (
Section
4.2
) for LonWorks
port (
Section
4.3
)
5. Use a browser to access the embedded tool, which is referred to in this manual as the Web
Configurator, to select the device that will be attached to COM CARD and set the Modbus
Node-ID. Once the device is selected, the COM CARD Automatically builds and loads the
Configuration. (
Section
5
)
6. BACnet/IP or Modbus TCP/IP (Option 3): Use a browser to access the COM CARD Web
Configurator to change the IP Address. No changes to the configuration are necessary. (
Section
5.4
)
7. LonWorks (Option 4): The COM CARD must be commissioned on the LonWorks Network. This
needs to be done by the LonWorks administrator using a LonWorks Commissioning tool.
(
Section
8
)
