TK-5210
(
G
)
45
ADJUSTMENT
Controls
6
Volume
Selector
Side 1 key
Side 2 key
PTT switch
Concentric Switch
Lever switch
Orange key
Universal
connector
Side 3 key
Panel Test Mode
(K2, K3 and K7 models only)
For the K model (without LCD), perform “Test mode” us-
ing the KPG-95DG.
■
Test mode operation features
This transceiver has a test mode. To enter panel test
mode, press and hold the [Side3] and [PTT] keys while turn-
ing the transceiver power ON and then the [PTT] key fi rst.
Test mode can be inhibited by programming. To exit test
mode, turn the transceiver power OFF.
• When the panel test mode is activated, the channel se-
lected with the [Selector] knob and the last used signal-
ing number are displayed. When it is activated for the
fi rst time, the signaling number is 1.
• If test signaling 26 (Tone Pattern) is selected, the result
of Bit Error Rate (BER) calculation is displayed on the
LCD. The BER value is also output from the serial port.
• The P25 and analog modes are switched automatically by
selecting test signaling. When P25 mode is effective, “A”
is displayed on the LCD.
• Key operation
Key Function
Display
[Selector]
Test frequency channel
up/down
Channel No
[Concentric
switch]
Channel spacing switching
(Position “A”: Wide,
Position “B”: Narrow,
Position “C”: P25)
Wide: “W”
Narrow: “N”
P25: “A”
[Lever
switch]
RF output power switching
(
K
: Low power,
●
: High power)
Low power: “LO”
High power: “HI”
[PTT]
Transmit -
[Side1]
Squelch level change
(0
→
1
→
2
→
...
→
9
→
0
→
1
→
2
→
...
)
Squelch level 0:
“SQ.LV0”
Squelch level 1:
“SQ.LV1”
Squelch level 9:
“SQ.LV9”
[Side1]
Hold
Squelch off
[Side2]
MSK baud rate change
(1200bps/2400bps)
2400bps:
icon appears
[Side2]
Hold
Compander on/off
On:
icon appears
[Side3]
Shifts to the Panel tuning
mode
-
[Side3]
Hold
LCD all lights
LCD all point appears
[Orange]
Beat shift on/off
On:
icon appears
[A] AFC
on/off
On:
icon appears
[B] Unused
-
[C]
Test signaling down
Signaling No.
[D]
Test signaling up
Signaling No.
[0] to [9]
and
[#], [ ]
Use as the DTMF keypad.
If a key is pressed during
transmission, the DTMF
corresponding to the key that
was presses is sent.
-
• LED indicator
Red LED
Lights during transmission.
Blinks at the low battery voltage warning.
Green LED
Lights when there is carrier.