TK-5210
(
G
)
17
■
Procedures when Replacing the Top Panel
1. Insert the O-ring
q
into the lever switch part of the new
top panel.
2. Apply grease to the base of the shaft of the lever knob
w
and install the lever knob so that it is in the “
●
” posi-
tion (circle painted in white) on the top panel
e
.
3. Pass the hardware fi xture
r
through the shaft and install
it onto the top panel.
4. Apply grease to between the two holes in the hardware
fi xture
r
.
5. Install the hardware fi xture
t
so that it is inserted into
the hole on the left side of the hardware fi xture
r
.
6. Fix the two hardware fi xtures with the hexagon nut
y
.
7. Apply bond (Three Bond 1401C) to the tip of the lever
knob shaft and the surface of the hexagon nut
u
.
Apply grease to between
the two holes in
the hardware fixture.
Apply bond (Three Bond 1401C)
to the tip of the lever knob shaft
and the surface of the hexagon
nut.
Top panel
Inserted into the hole
on the left side of the
hardware fixture.
Apply grease to the
base of the shaft of
the lever knob.
:
;
>
=
B
@
.
■
Volume Knob and Channel Knob Parts
Replacement
Since the volume knob consists of two components, a
knob
q
and a spacer
w
, replace and reinstall these two
parts at the same time.
Since the channel knob consists of three components, a
knob
e
, a 16CH display seal
r
and a spacer
t
, replace
and reinstall these three parts at the same time.
Volume Knob
Channel Knob
:
.
=
;
@
■
Procedure when replacing the universal
connector FPC (J82-0097-25)
When assembling a new universal connector FPC, insert
the FPC into the chassis hole by gently bending the FPC
as shown in the fi gure.
Universal
Connector
Do not bend the FPC at a sharp angle.
Universal connector FPC
Wrong
Universal
Connector
Bend the FPC gently.
Universal connector FPC
Universal connector FPC
(J82-0097-25)
Right
DISASSEMBLY FOR REPAIR