Kemper 345plus, Руководство оператора

Страница: 89 / 126

Operating the Rotary Harvesting Unit
KM00321,0000815 -19-03JUL18-1/1
KM00321,000054B -19-21JUN16-1/1
Lengths of Cut and Gear Selection with
Multi-Speed Drive for CLAAS Forage
Harvesters
See table below to determine length-of-cut adjustment.
NOTE: The grayed out lengths of cut may under certain
circumstances lead to problems in the material flow.
Lengths of cut in mm
4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
Gear selection (4 gears)
20-knife
cutterhead
- -
1 1 1 2 2 3 3 3 4 4 4 4 4
24-knife
cutterhead
-
1 1 1 2 2 3 3 4 4 4 4 4 4 4
28-knife
cutterhead
1 1 1 2 2 3 3 4 4 4 4 4 4
- -
36-knife
cutterhead
1 2 2 3 3 4 4 4 4 4
- - - - -
IMPORTANT: Claas forage harvesters of the types
498, which are fitted with a variable header
drive, can change the speed within the cutting
length settings. In order to avoid very high
drum speed, you cannot use the 4th gear of
the multi-speed transmission.
NOTE: When the 3rd gear is operated with maximum
variable speed, this corresponds with the 4th gear.
Calibrate Steering Assistance (Rotary
Harvesting Units for CLAAS Forage
Harvesters)
CLAAS forage harvesters, Types 492 and 493:
Disconnect the calibration plug (A).
IMPORTANT: Do NOT reconnect the calibra-
tion plug (A).
CLAAS forage harvesters, Types 494 and 496:
Disconnect calibration plug (A) before calibrating the
steering assistance.
NOTE: See forage harvester operator’s manual for
calibration of the steering assistance.
IMPORTANT: Reconnect calibration plug (A) after
calibrating the steering assistance.
A—Calibration Plug
KM210172
—UN—31MAR14
KM210173
—UN—31MAR14
35-15 031519
PN=89