Kemper 345plus, Руководство оператора

Страница: 112 / 126

Service
KM00321,000019F -19-10AUG12-1/1
Disassemble Slip Clutch
If it is not possible to rotate the slip clutch by hand as
described under Relieve Pressure at the Slip Clutches on
the Main Drive, it is necessary to disassemble and clean it
for proper function. Proceed as follows:
1. Remove slip clutches from rotary harvesting unit. See
Removal of Slip Clutch in this Section.
2. Tighten the nuts (A). This will relieve pressure on the
friction plates.
3. First remove locking collar (I) from housing (B).
4. Then remove all parts of slip clutch from housing (B).
5. Clean all parts, especially friction disks (C, E). Replace
worn parts.
6. Reassemble all parts.
7. Install locking collar (I) as shown in Torque Settings
below.
8. Slacken off nuts (A) to the end of their threads.
9. Reinstall slip clutch on rotary harvesting unit.
Torque setting:
IMPORTANT: The specified torque of 1150 N·m (848.2
lb.-ft.) for model 390
plus
and 900 N·m (657 lb.-ft.)
for all other models must not be exceeded.
The torque is set by positioning profile (F) of locking
collar (I) towards the outside. Depending on the rotary
harvesting unit model, the lugs of locking collar (I) must
be engaged in inner (H) or outer (G) recesses.
390
plus
rotary harvesting unit:
Engage the lugs of locking collar (I) in inner recesses (H)
of housing (B).
345
plus
, 360
plus
and 375
plus
rotary harvesting units:
Engage the lugs of locking collar (I) in outer recesses (G)
of housing (B).
KM1000160
—UN—16OCT07
KM1000161
—UN—16OCT07
KM1000996
—UN—31AUG09
A—Nut
B—Housing
C—Friction Disk
D—Coolant Reservoir - 1.3 L
(0.34 US gal.)
— 0.65 L (0.17 US gal.) Water
— 0.65 L (0.17 US gal.)
Anti-Freezing Compound
E—Friction Disk
F— Profile
G—Outer Recess
H—Inner Recess
I— Locking Collar
55-5
031519
PN=112