KDF Plus Series, Инструкция по эксплуатации

Страница: 25 / 31

23
◆
"Back Light" setting
・
Set the LCD backlight off time. If no key is operated for the set time, the backlight turns off.
Also, if you press any key while the light is off, it will return.
If you set 0 minutes, it will not go out.
Setting
range
：
0 to 120 minutes Initial value
：
0 minutes
◆
"Sensor Type" setting
・
Change to "P" when the optional high temperature sensor (platinel thermocouple) is attached.
Since the standard is equipped with a K thermocouple, the initial value is "K".
◆
"SD Error" setting
・ This unit can record the operation contents on the SD card, but if the SD card is not inserted at the
start of operation, it will start operation without recording. If you want to detect the SD card error at the
start of operation, set it in this section.
Setting
value
：
No (initial value) "SD card error detection is not performed at the start of operation"
Yes “If there is an error at the start of operation, a confirmation screen
will be displayed.”
※
Either this setting is set, recording will be performed if the SD card is properly inserted.
◆
"Abnormal Temp. Rise" setting
・
Set the operating temperature of the excessive temperature rise abnormality detection circuit of this
machine. Normally, it is not necessary to change the value for the purpose of protecting this machine
at the time of failure and fire prevention, but change the value if you want to regulate the upper
temperature
limit to protect the burned material.
・
There is an error of about ±30
℃
in the set value, so consider the error and set it higher by 50 to 100
℃
.
Setting
range ： 300 to 1250 ℃（ 50 ℃ unit ）
Maintenance mode
・
Press the "F4" (Maintenance) key in standby mode to switch to this mode.
In this mode, you can check energization time, error count, SD card operation, and PID constant editing.