KDF Plus Series, Инструкция по эксплуатации

Страница: 13 / 31

11
Installation of this machine
■
Installation location
／
environment
・
In order to operate the muffle furnace normally, please prepare the following power supply equipment
according to the product.
300Plus
： AC100V 50/60Hz, current capacity 20A
500Plus ： Single-phase AC200V 50/60Hz, current capacity 20A
1500Plus
：
Single-phase AC200V 50/60Hz, current capacity 30A
3000Plus
：
Single-phase AC200V 50/60Hz, current capacity 40A
5000Plus
：
Single-phase AC200V 50/60Hz, current capacity 50A
・
Install in a place with little dust and near the power supply facility.
・
Install this machine on a horizontal and sturdy table, and fix it to a sturdy structure with metal wires,
etc., to prevent it from falling.
・
Install the unit at a distance of 100 cm on the top and at least 30 cm away from walls and equipment.
Also, do not place any objects on the top surface of this machine.
■
Wiring work
・
For 300Plus
：
The power cord comes out of the main unit. Connect it to the grounded outlet of the power circuit
prepared for this unit alone. Do not use a plug adapter, etc. There is a risk of fire or electric shock.
・ For other than 300Plus ：
Connect the supplied power cord to the power terminal of this machine, and then connect it to the
power equipment prepared exclusively for this machine.
The green wire of the power cord becomes
the ground wire.
※ Be sure to connect the ground wire to a properly constructed ground terminal.
■
Installation of hearth plate
・
Please lay the attached hearth plate on the bottom of the furnace.
※
For 5000Plus, lay two attached hearth plates on the bottom of the furnace.
●
If you place the fired product directly on the hearth plate, the temperature may be lower
than the furnace temperature, so adjust it with a spacer such as refractory so that it is
placed in the center of the furnace as much as possible.
●
The hearth plate is necessary to protect the heat insulating material inside the furnace.
Never use without the hearth plate.
● Since the hearth plate and the fired product may react with each other and damage
each other, put the fired product in a tray or crucible that does not react with the fired
product (alumina, mullite, etc.) before placing it on the hearth plate.
■
Installation of exhaust guide and exhaust port plug
・
Depending on the application, insert the attached exhaust guide or exhaust port plug into the hole near
the center of the furnace top surface. Insert the thin outer shape through the hole.
Exhaust
guide ： When installing a deodorizer or smoke exhaust device, install an exhaust guide.
Exhaust plug ： If you are not using a deodorizer, insert the exhaust plug into the hole to close it.
CAUTION