12
Getting Ready
Removing the au IC card
Press the lock with
the finger (
①
) and
pull the au IC card
out 2-3 mm in the
direction of the
arrow
②
Lift your finger from
the lock and press
the au IC card lightly
to slide out to the
direction or arrow
②
• Do not press the au
IC card downward with
excessive force.
◎ Note the following points, which may cause malfunction or
damage, when handling the au IC card.
•
Do not touch the IC (metal) part of the au IC card or the IC
card terminal inside the IS11T.
•
Insert the IC card in the correct direction.
•
Do not use force to attach or remove the IC card.
◎ An error message is displayed if the au IC card is not attached
correctly or if there is a problem with the au IC card.
◎ Do not lose the au IC card after it has been removed.
Lock
②
①
Charging
When you purchase your terminal, the battery pack is not fully
charged. Be sure to charge the battery pack before use.
■ Charging times (approximate)
These times are to fully recharge the battery pack while
the IS11T is turned off. The charging times increase if the
power is on or the temperature is low during charging.
Common AC adapter 03
(sold separately)
Approximately 140 minutes
Common DC adapter 03
(sold separately)
Approximately 200 minutes
■ Adapter for charging
In addition, the specified AC adapter (sold separately) or DC
adapter (sold separately) is needed.
◎ The common AC adapter 01 (sold separately) uses 100 VAC
used for households in Japan. Do not use single-phase 200 V
current or voltage converters used overseas.
◎ The common AC adapter 02/03 (sold separately) supports 100
to 240 VAC. Use only the common AC adapter 02/03 (sold
separately) for charging overseas.