KAYO MOTOR TD125, Руководство по обслуживанию

Страница: 88 / 93

worn
he fit clearance between the
main and driven gears is too
small or too large
Motorcycle cleaning
Vehicle cleaning is also an important part of the daily use and maintenance of motorcycles, often clean your
motorcycle, can make your car to maintain a good state of motion, prolong its service life. You can clean your
motorcycle by following the steps:
1. Cover the exhaust system to prevent water from entering;
2. Seal the electric door lock and connectors with tape;
3. Remove mud and dirt from the surface with a low-pressure water jet;
4. Use special motorcycle cleaner to clean the particularly dirty place;
5. Rinse with low pressure water;
6. Let the motorcycle dry naturally;
7. Drive the motorcycle for a short period of time until the engine reaches the operating temperature;
8. Lubrication chain and all other parts that need lubrication.
Warning: Do not use high pressure water to clean vehicles. Avoid direct contact with the coil, plug, carburetor or
any electrical element.
Storage of motorcycles
The preparation of the motorcycle before long unused
When you plan to store your vehicle and not use it for a long
time, follow these steps:
1. Plug the exhaust port of the muffler cylinder;
2. Take out the battery.
3. Clean the motorcycle thoroughly;
4. Wait for the motorcycle to dry naturally;
5. Empty the tank (if not used for a long time, the gasoline will
deteriorate);
6. Lubrication chain;
7. Apply oil to all unpainted metal surfaces to prevent rust;
8. When storing the motorcycle, keep the motorcycle wheel
suspended, if the condition cannot be reached, the cardboard
pad can be used under the motorcycle tire;
9. Cover your motorcycle to prevent dirt and dirt from sticking.
10. Move the motorcycle into a dry room.
Note: When applying anti-rust oil, please do not splash the oil
on the brake and rubber parts, otherwise it may make the rubber
aging.
Prepare a motorcycle before it is put into use
After storing the motorcycle for a long time, please follow the
following steps when putting it into use:
1. Take out the plug at the exhaust vent of the muffler cylinder.
2. Tighten the spark plug.
3. Fill the tank with fuel;