KAYO MOTOR TD125, Руководство по обслуживанию

Страница: 51 / 93

The throttle cable inspection is carried out from the following
aspects:
1.Turn the throttle handle and feel if the throttle recoils
smoothly
2.Start the motorcycle engine, turn the head left and right, and
observe whether the engine power changes because of the head
movement. If there is a change, it indicates that the throttle
cable stroke is short.
Inspection of the handle bar
Let the rider sit on the motorcycle with both hands on the handlebars naturally. Feel whether the position of clutch
grip and brake grip is comfortable. If it is difficult to control, then the position of steering grip is determined.
Check and maintain the brake system
Check the free stroke of the front brake handle
The brake handle inspection is carried out from the following
aspects:
1.The right hand rests naturally on the right handle
2.Use the forefinger and middle finger of your right hand to
check for free movement. Both fingers should be able to hook
and pull the handle
3.Pinch and release the handlebar and feel the resistance each
time you do it.
4.If you feel soft when pinching, the oil pump or oil pipe may
be mixed with air, at this time you should check the entire
brake system and take appropriate measures
Inspection of the disc brake
Break disc
The disc brake inspection is carried out from the following
aspects:
1.Check whether there are cracks, dents and other damage on
the surface of the disc brake.
2.Measure the thickness of the disc and compare it with the
limit thickness. If it is less than or equal to the limit thickness
of the disc, the disc must be replaced immediately.
Disc brake limit thickness table is as follows:
Front limit thickness Rear limit thickness
TD125 3.0mm 3.0mm
Check the fluid level of front brake disc
21 TD125 uses hydraulic disc brake, and its disc brake fluid
level can be checked through the observation hole.