The checking of the chain is carried out from the following
aspects:
1.Inspect the chain from the back of motorcycle to see if the
chain is skewed.
2.Turn the rear wheel by hand to see if the rear wheel turns
smoothly.
3.Carefully check the chain clearance to see if there is sediment
attached.
The chain cleaning steps are as follows:
Use special cleaning agent to wash the silt and oil in the surface
and clearance of the chain, wait until the chain naturally dry,
and then brush a layer of antirust oil on the surface of the chain.
Disassembly and assembly of the chain
Steps of disassembly and assembly of the chain are as follows:
1.Remove the spring plate on the chain.
2.Remove the chain moving section.
3.Pull the chain out from under the sprocket
4.Assembly shall be carried out in the reverse order of
disassembly.
Check and adjust the chain tension
The chain transfers the power output from the engine to the wheels and makes the motorcycle move normally. It is
an important part of the motorcycle. Therefore, the chain needs to be regularly checked and maintained to ensure
its normal use.
The chain tension can be adjusted according to requirements, as shown below:
1.The motorcycle is fixed so that the rear wheel is completely suspended;
2.Measure the distance between the back of the swing arm and the chain, the normal distance should be 30 ~
40mm, about the width of two fingers. The distance is close to the normal distance, do not have to be very
demanding;
3.Loosen the rear axle nut;
4.Find the position of maximum tension in the chain under the condition of satisfying the normal spacing;
5.Through the nut on the tensioner, using the notch on the tensioner and the lugs on the adjuster, make the two
ends of the awing arm aligned;
6.Screw the tensioner nut;
7.Tighten the rear axle nut;
8.Check the maximum tension point and readjust the tension if necessary.
When checking the chain tension, in addition to the chain, the guide rail and sprocket of the chain should also be
visually inspected.
When the chain is used excessively or the stretching amount exceeds 2%, the chain should be replaced, and the
corresponding guide rail and sprocket should also be replaced. If the chain is only replaced without other parts, the
service life of the new chain will be shortened due to the wear and tear of other parts caused by the old chain, and
these parts will soon reach the limit of use, so that they have to be replaced. Therefore, even from an economic
point of view, it is worthwhile to replace the whole chain drive system at the same time. The replacement parts
should use the original production or authorized products of KAYO.
The chain needs to be lubricated regularly, see General Lubrication section for details.
Содержание TD125
