2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 11 | Mechanical Properties
Figure 5 – Pulling the pull tab latch of a QSFP+ Module
Figure 6 – Removing a QSFP+ Module from its port
5.8
Dual SFP+ Installation
5.8.1
Installing the SFP+ Module
In order to install the SFP+ module, follow these steps:
1.
Remove the dust plugs from the module.
2.
The SFP+ module has a bale clasp that used to remove or install the SFP+ module.
3.
Close the bale clasp before inserting the SFP+ module into the JetCam camera.
4.
Line up the module with the port and slide it into the port.
5.
Make sure that the male connectors on the module will align with the female connectors inside the
cage.
6.
Verify that the modules are completely seated and secured in their assigned receptacles on the line card
by firmly pressing on the module with your thumb. In case the module is not completely seated and
secured, you will hear a click as the triangular pin on the bottom of the module snaps into the hole in
the receptacle.
Figure 7 – Insert the SFP+ module into the socket
