Kaya Instruments JetCam, Руководство пользователя

Страница: 24 / 58

2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
www.kayainstruments.com Page no. 21 | Configuration Interface
Exposure Time Sets the Exposure time when
ExposureMode is Timed
ExposureTime Float ≥ 1.0 In units of
microseconds (us)
See remark (1)
Exposure Strobe
Monitor Mode Select to generate a strobe
signal of sensor exposure ExposureStrobeMonitorMode Enumeration 0 Off
1 ExposureActive
Exposure Strobe
Monitor Invert Controls the inversion of the
signal generated according to
ExposureStrobeMonitorMode ExposureStrobeMonitorInvert Boolean 0 False
1 True
Trigger Selector Selects the type of trigger to
configure
TriggerSelector Enumeration 0 FrameStart
Trigger Source Specifies the internal signal or
physical input Line to use as
the trigger source TriggerSource Enumeration 0 LinkTrigger0
1 Line1
Trigger Software TriggerSoftware Command 1 - Activate
Table 13 – Acquisition Control parameters
Remarks:
1.
Controls the duration where the photosensitive cells are exposed to light.
7.3.2 Exposure Time
Time in microseconds [µsec] in which sensor is exposed to light. This time is subject to the specified image frame
rate:
𝑚𝑖𝑛𝑖𝑚𝑢𝑚 𝑒𝑥𝑝𝑜𝑠𝑢𝑟𝑒 ≅ 6
𝑚𝑎𝑥𝑖𝑚𝑢𝑚 𝑒𝑥𝑝𝑜𝑠𝑢𝑟𝑒 ≅
1,000,000
𝑓𝑟𝑎𝑚𝑒 𝑟𝑎𝑡𝑒
Additional delays might be taken to consideration in calculation of exposure values, like delay between frames,
etc.
7.3.3 Auto Exposure & Gain Algorithm
Auto Exposure and Gain features used to control the picture brightness by adjusting Exposure and Gain values in
automatic mode in order to reach desired brightness level. The algorithm calculates the average picture
intensiveness inside the defined ROI and tries to adjust it to desired brightness level. The brightness is adjusted by
increasing/decreasing exposure time and/or analog gain level. Three modes are available for automatic brightness
adjustment:
7.3.3.1 Auto Exposure Mode
When operating in this mode, the camera tries to reach the desired brightness level of the picture by adjusting
Exposure Time.