2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 10 | Mechanical Properties
6.
Verify that the modules are completely seated and secured in their assigned receptacles on the line card
by firmly pressing on the module with your thumb. In case the module is not completely seated and
secured, you will hear a click as the triangular pin on the bottom of the module snaps into the hole in
the receptacle.
Figure 3 – Insert the QSFP+ module into the socket
5.7.2
Connecting the interface cable to QSFP+ Module
In order to properly connect the QSFP+ Fiber Breakout cable, the following steps must be taken:
1.
Remove the protective dust cover from the fiber-optic cable connector.
2.
Insert the fiber cable into the module.
3.
Firmly push on each cable, until you will hear a click.
4.
Connect the other side of the QSFP+ Fiber Breakout cable to your Frame Grabber device.
Figure 4 – Connecting the QSFP+ cable
5.7.3
Removing the QSFP+ Module
1.
Turn the JetCam camera off.
2.
Disconnect and remove all interface cables from the ports.
3.
Hold the pull-tab latch on the QSFP+ module with your index finger, and gently pull to release the
transceiver from the socket.
4.
Grasp the module between your thumb and index finger and carefully remove it from the port.
5.
Insert the clean dust covers into the module.
