KaVo ELECTROmatic TM, Инструкция по эксплуатации

Страница: 69 / 90

Instructions for use ELECTROmatic TM and TMM/TMC
6 Operation | 6.5 ENDO Mode
6.5.4 Selecting an ENDO file sequence
▶ Select ENDO file sequences using the "File sequence" selection list by press-
ing the desired file sequence (presently SEQUENCE 1).
ð
The display shows the selected file sequence.
6.5.5 Selecting ENDO files
Each file sequence has up to 10 files (E0 to E9) assigned to it. Usually, these 10
files are used in sequence proceeding from E0 to E9 depending on the indica-
tion.
▶
Press E0 to E9, moving the selection list up or down, if needed, to select a
file.
ð
The selected file is shown with a white background, presently: E3.
6.5.6 Setting the ENDO speed
Note
Changes of speed or torque in ENDO mode are not saved permanently and
are available only until you exit from the view. In order to save the speed or
torque permanently, the speed or torque need to be set in the file editor.
See also:
2 Defining/changing ENDO file sequences
File "E0" has, e.g., speed 400 rpm assigned to it.
▶ If the torque is active, activate the speed by touching the speed value.
▶
To change the speed pull the slider to the right or left.
69 / 90