KaVo ELECTROmatic TM, Инструкция по эксплуатации

Страница: 62 / 90

Instructions for use ELECTROmatic TM and TMM/TMC
6 Operation | 6.5 ENDO Mode
62 / 90
Reduction ratio of con-
tra-angle handpieces Torque of the file Minimum/maximum
attainable torques
1:1 (M20 L with L68 B)
1:1 (S20)
1:1 (S20 S) 0.15 – 2.0 Ncm 0.15/3.0 Ncm
3:1 (M20 L with L66 B) 0.5 – 6.0 Ncm 0.45/6.0 Ncm
8:1 (ENDO S81) 1.5 – 6.0 Ncm 1.2/6.0 Ncm
▶
Press the control element, "ENDO"/"PREP", to toggle between Preparation
and ENDO mode.
ð
If the display shows the "ENDO" control element, ENDO mode is active.
6.5.1 Using the ENDO mode
Requirement
The ENDO function is available only on motor connector "M1", which corres-
ponds to the motor shown on the left side of the display.
Operation general
Activated values are shown with a blue background and can be changed.
Deactivated values are shown with a grey background.
▶ To change a value with a grey background, activate the value by touching
it.
▶
Once the value is activated, use the slider to set the value.
6.5.2 File database
ELECTROmatic TM and TMM/TMC possess an integrated file database. It is ne-
cessary to check if the file data are up-to-date by comparing them to the re-
spective manufacturer information. Speed and torque of the files in the file
database correspond to the maximum permissible values of the respective
manufacturer.
The file database includes data on the following file systems and manufactur-
ers: