Kathrein UFD 560, Руководство по эксплуатации

Страница: 13 / 52

Putting into operation
13
If “Bad or No signal” appears on the display and the last received
program is shown then you should check the antenna cable and/or
the settings of the receiver. If this only effect individual programs then
this may be caused by an interruption of the signal from the trans-
mitter or a fault in the cable system.
You should then first check the connection configuration and then
whether the basic settings of the receiver are correct for your system.
When in doubt, have en expert do this.
Factory settings of the receiver
Please make a note of the basic settings of your receiver before
changing them! This will allow you to switch back to the original
settings at any time.