Kaisai Split ECO HOME, Руководство по эксплуатации

Страница: 24 / 38

Operation Instructions for Air-to-water Heat Pump Split ECO HOME Operation Instructions for Split Versati
21
SPLIT TYPE
(b) This setting is allowed only when the unit is turned off.
2.2.26 Tank Sensor
When the water tank has been installed, one group or two groups of tank sensors can be selected to detect and
control the water tank temperature.
[Operation Instructions]
Go to the FUNCTION page and locate “ Water tank , “ 1 ”
or “ 2 ”. When the water tank is unavailable, this option will be reserved.
[Notes]
It will be memorized upon power failure.
2.2.27 Solar Heater
With ” or “ Without ” based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate “ Solar heater ,
“ With ” or “ Without ”.
[Notes]
It will be memorized upon power failure.
With
” or “
Without
” based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate “ ,
“
With
” or “
Without
”.
[Notes]
(a) It will be memorized upon power failure.
(b) Under the heating mode, when it is set to “
With ”, the setting value is defaulted to be the normal water
temperature and cannot be changed; when it is set to “ Without ”, the setting value can be changed freely.
Under the cooling mode, when it is set to “ With ”, the leaving water temperature range is 18-25 and the
default is 18 ; when it is set to “ Without” , the range is 7-25 , the default is 7 .
(c) “ ” can be changed only when the unit is turned off.
(d) Floor
” should be manually set to “ Without ” for getting lower leaving water temperature. When the radiator
is used for heating, “ ” also should be manually set to “ Without ” for getting higher leaving water
temperature.
2.2.29 Remote Sensor
With ” or “ Without ” based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate “ Remote sensor ”, then, configure it through the Up/Down key
, “ With ” or “ Without ”.
[Notes]
(a) It will be memorized upon power failure.
(b) “
T-room ctrl ” can be selected only when the Remote Sensor is set to “ With ”.
2.2.30 Air removal
This function is intended to expel air inside the water system with only the water pump in operation when