Kaisai Split ECO HOME, Руководство по эксплуатации

Страница: 12 / 38

Operation Instructions for Air-to-water Heat Pump Split ECO HOME Operation Instructions for Split Versati
9
SPLIT TYPE
heating, “ ” also should be manually set to “ Without ” for getting higher leaving water temperature.
[Operation Instructions]
After “
” is set to “ Without ” (see 2.2.28), go to the FUNCTION page and locate “ T-water ctrl .”, then,
, “ High temp .” or “ Low temp. ”.
[Notes]
(a) When this setting is changed, the following parameters will return to the default values.
Full Name Displayed Name Default
Water out temperature for cooling WOT-Cool
7°C/45°F[Low]
18°C/64.8°F[Normal]
Water out temperature for heating WOT-Heat
45°C/113°F[High]
35°C/95°F[Normal]
Upper limit water-out temperature at the weather-dependent mode
for heating
Upper WT-Heat
48°C/118°F[High]
35°C/95°F[Normal]
Lower limit water-out temperature at the weather-dependent mode
for heating
Lower WT-Heat
40°C/104°F[High]
29°C/84°F[Normal]
(b) This setting will be memorized upon power failure.
2.2.5 Cool + Hot water
This compound mode enables the user to give priority to the “
Cool
” or “
Hot water
” mode depending on the
actual demand.
[Operation Instructions]
Go to the FUNCTION page and locate “ Cool+hot water ”, then, configure it through the Up/Down key
, “
Cool
” or “
Hot water
”.
[Notes]
(a) “ Hot water ” will take precedence only when “ Water tank ” is available, other it will tell “ Reserved ”.
(b) This setting will be memorized upon power failure.
2.2.6 Heat + Hot water
This compound mode enables the user to give priority to the “
Heat
” or “
Hot water
” mode depending on the
actual demand.
[Operation Instructions]
Go to the FUNCTION page and locate Heat+hot water , then, configure it through the Up/Down key
, “
Heat
” or “
Hot water
”.
[Notes]
(a) “ Hot water ” will take precedence only when “ Water tank ” is available, other it will tell “ Reserved ”.
(b) This setting will be memorized upon power failure.
2.2.7 Quiet
This function can be activated when the running noise is too high.
[Note]
when this function is activated, frequency of both the compressor and the fan will go down and also the capacity
of the unit will correspondingly decrease.
[Operation Instructions]
Go to the
FUNCTION
page and locate “
Quiet
, “
On
” or
“ Off ”.
[Notes]
(a) It can be set to “ On ” or “ Off ” no matter if the unit is in operation or not.
(b) Once it is activated, it should be deactivated manually or by Quiet Timer .
(c) This setting will be memorized upon power failure.