KAESER ESD 352 SFC, Техническая документация инструкция

Страница: 79 / 413

5 Installation and Operating Conditions
5.1 Ensuring safety
The conditions in which the machine is installed and operated have a decisive effect on safety.
Warning instructions are located before a potentially dangerous task.
Disregard of warning instructions can cause serious injuries!
Complying with safety notes
Disregard of safety notes can cause unforeseeable dangers!
➤ Strictly forbid fire, open flame and smoking.
➤ If welding is carried out on or near the machine, take adequate measures to prevent sparks or
heat from igniting oil vapours or parts of the machine.
➤ Do not store inflammable material in the vicinity of the machine.
➤ The machine is not explosion-proof!
Do not operate in areas in which specific requirements with regard to explosion protection are
in force.
For instance, the requirements of ATEX directive 94/9/EC "Equipment and Protective Systems
intended for use in Potentially Explosive Atmospheres".
➤ Ensure sufficient and suitable lighting such that the display can be read and work carried out
comfortably and safely.
➤ Keep suitable fire extinguishing agents ready for use.
➤ Ensure that required ambient conditions are maintained.
Required ambient conditions may be:
■ Maintain ambient temperature and humidity
■ Ensure the appropriate composition of the air within the machine room:
─ clean with no damaging contaminants (e.g., dust, fibres, fine sand)
─ free of explosive or chemically unstable gases or vapours
─ free of acid/alkaline forming substances, particularly ammonia, chlorine or hydrogen sulfide.
5.2 Installation conditions
5.2.1 Determining location and clearances
The machine is intended for installation in an appropriate machine room. Information on distances
from walls and ventilation is given below.
The distances quoted are recommended distances and ensure unhindered access to all ma‐
chine parts.
➤ Please consult KAESER if you cannot comply with these recommendations.
Precondition The floor must be level, firm and capable of bearing the weight of the machine.
5 Installation and Operating Conditions
5.1 Ensuring safety
ESD_2C_10357405_10–LIN_00 E
Service Manual Screw Compressor
ESD 442/14 bar (abs) SFC SIGMA CONTROL 2
33