KAESER ESD 352 SFC, Техническая документация инструкция

Страница: 319 / 413

Installing the Ethernet cable
Use a cross-link Ethernet cable for the direct connection of two machines.
Fig. 31 Direct connection of two SIGMA CONTROL 2
1
Controller machine 1 (Master mode)
2
Ethernet interface X1
3
Ethernet cable, cross-link cable
4
Controller machine 2 (Slave mode)
5
Ethernet interface X1
➤ Install the Ethernet cable between the two machines.
For connecting the machines to a network (LAN):
➤ Install the Ethernet cable from each machine to the next LAN connection.
Connecting the Ethernet cable with the machine
For each machine:
1. Insert the Ethernet cable into the machine and the machine's control cabinet, using an EMC
connection.
2. Lead the Ethernet cable through the cable ducts to SIGMA CONTROL 2 . Use the wiring path
in the 24V range (blue wiring) of the ducts.
3. Install the Ethernet bus plug at the cable end.
4. Push the bus plug into the Ethernet interface X1 of the SIGMA CONTROL 2 until it latches.
For connecting the machines to a network (LAN):
Connect the Ethernet cable for each machine to the LAN connection.
1. Install the Ethernet bus plug at the cable end.
2. Push the bus plug into the LAN socket until it latches.
7.9.4.2 Configuring the controller of machine 1 as master
Precondition The electrical connection is made.
7 Initial Start-up
7.9 Configuring the machine for master control
100
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
9_9450 03USE