KAESER ESD 352 SFC, Техническая документация инструкция

Страница: 323 / 413

Example:
■ Controller machine 1 (Master mode): 169.254.100.101
■ Controller machine 2 (Slave mode): 169.254.100.102
1. Select
< Communication ➙ Ethernet ➙ IP configuration >.
2. Enter IP address for the master.
3. Select
< Communication ➙ Ethernet ➙ Connections ➙ SIGMA CONTROL 2 >.
4. Press «DOWN» twice.
5. Press «Enter» to switch into setting mode.
6. Use «UP» to set the controller of machine 2 to “Slave”.
7. Press «Enter» to accept the setting.
8. Press «DOWN» four times.
9. Press «Enter» to switch into setting mode.
10. Enter the IP address of the communication partner (master).
11. Press «Enter» to accept the setting.
7.9.5 Configuring for master control using the LOAD remote contact (e.g.,
SIGMA AIR MANAGER BASIC)
Overview
■ Making the electrical connection for LOAD remote contact
■ Setting the LOAD remote contact operating mode and assign the input
■ Adjusting the pressure increase pE, if necessary.
■ Activating the «Remote control» key
➤ Configuring master control as described below.
7 Initial Start-up
7.9 Configuring the machine for master control
104
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
9_9450 03USE