KAESER ESD 352 SFC, Техническая документация инструкция

Страница: 374 / 413

1. Log on to SIGMA CONTROL 2 with password level 2. (see section 7.2.6).
2. In operating mode, switch to the main menu with the «Enter» key.
3. Select the
< Machine test ➙ TÜV inspection > menu.
Safety valve is displayed in the active line.
4. Press «DOWN» repeatedly until
Airend discharge temperature ADT ⇞ is displayed as the ac‐
tive line.
5. Press «Enter» to switch into setting mode.
The check box in the active line flashes.
8 9 p s i 0 8 : 1 5 1 6 3 ° F
Fallen airend discharge temperature ( 163 °F )
9.1 TÜV inspection
Menu
·········
Airend discharge temperature ADT ⇞ : ☐
Active line
Offset : 0 °F ¦ ADT ⇞ 0.0 °F
Reset: ☐
6. Use the «UP» key to activate the check box.
7. Press «Enter» to accept the setting.
The
Offset display changes to 95 °F.
The
Airend discharge temperature ADT ⇞ display changes to 226 °F.
The test mode is now activated.
8 9 p s i 0 8 : 1 5 1 6 3 ° F
9.1 TÜV inspection
Menu
·········
Airend discharge temperature ADT
⇞ : ☑
Active line
Offset : 95 °F ¦ ADT ⇞ 226 °F
Offset, airend discharge temperature in test mode
Reset: : ☐
8. Press the «ON» key to switch the machine to LOAD.
The machine switches to LOAD and the airend discharge temperature rises again.
The machine will switch off as soon as the airend discharge temperature attains a value of
226 °F.
The machine does not shut down?
➤ Abort the test and contact KAESER Service as soon as possible.
Correct conclusion of the test
1. Press «Enter» to switch into setting mode.
The check box in the active line flashes.
2. Use the «DOWN» key to deactivate the check box.
8 Operation
8.11 Checking the temperature sensor and overheating shutdown function
9_9450 03USE
Service manual Controller
SIGMA CONTROL 2 SCREW FLUID 1.1.3
155