Establishing a connection to the KACO device
F
The device must be opened in order to connect the Ethernet cable! The device has 3 Ethernet ports that can be used.
These are located on the printed-circuit board marked LP400. In this application only one of the 2 neighboring shielded
Ethernet ports (marked LAN1 and LAN2) should be used. These ports have an internal switch and, in their factory de-
fault state, they expect to receive an IP address from a DHCP server.
ð
NOTE: Please do not under any circumstances connect the Ethernet cable to the unshielded RJ45 slot
marked J200 as this typically causes damage to the printed circuit board!
1. Use a functioning Ethernet slot on the external network end.
2. It may be necessary to take additional IT configuration measures in the external network so that the device is as-
signed an IP address.
3. Next, launch the browser on the terminal device and enter the IP address of the device:
ð
http://<IP address of the device>
ð
The IP address can either be requested from the network administrator or determined using an IP scanner tool.
4. There is also the option of addressing the device using its host name. In its factory default state, the host name con-
sists of a combination of the device derivative designation and the serial number, as shown below:
<Device designation serial number>, for example:
↻
or
5
F
If this is unsuccessful, please use the full domain name:
<ExternalNetworkDomainName> or http://bg92-92-0TL01234567<ExternalNetworkDo-
mainName>
5
If the device serial number features a “.” dot, then this “.” dot is replaced with a “-” dash in the host name as,
according to RFC229, host names must not contain any “.” dots.
For local host names, only characters in the range [a-z], [A-Z] and the minus character are permitted.
8 | Start-up
Manual
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137 TL3-S
Page 34
EN-US
