Configuration and Operation
Page 32
Operating Instructions KACO blueplanet 29.0TL3
EN
EN
Operating status
LEDs
Display
Description
Non feed-in
operation
Status message
The display shows the corresponding
message.
Fault
Fault message
The display shows the corresponding
message.
The red “Fault” LED is illuminated.
8.1.2 Graphical
display
The graphical display shows measured values and data and allows the configuration of the inverter using a graphi-
cal menu. In normal operation, the backlighting is switched off. As soon as you press one of the control buttons, the
backlighting is activated. If no button is pressed for an adjustable period of time, it switches off again. You can also
activate or deactivate the backlighting permanently.
1
2
3
4
5
6
7
8
Figure 41: Desktop
Key
1
Current date
5
Annual yield
2
Current power
6
Indicator for daily yield curve
3
Menu indicator
7
Current time
4
Daily yield
8
Feed-in indicator
After being switched on and after initial commissioning is complete, the inverter displays the start screen (the desk-
top). If you are in the menu and do not touch any control buttons for 2 minutes, the inverter returns to the desktop.
For initial commissioning, see section 8.2 on page 34.
NOTE
Depending on the tolerances of the measuring elements, the measured and displayed values are not
always the actual values. However, the measuring elements ensure maximum solar yield. Due to
these tolerances, the daily yields shown on the display may deviate from the values on the grid
operator’s feed-in meter by up to 15%.
NOTE
Calculating efficiency using the measured current and voltage values can lead to misleading results
due to the tolerances of the measurement devices. The sole purpose of these measured values is to
monitor the basic operation of the system.