Mounting
Operating Instructions KACO blueplanet 29.0TL3
Page 15
EN
Authorised electrician
CAUTION
Risk of injury caused by excessive physical strain.
Lifting the device for transportation or to change location can lead to injuries (e.g. back injuries).
›
The unit should only be lifted using the openings provided or a transportation device.
›
The unit must be transported and installed by at least 2 persons.
Unpacking the unit
ඣ
The unit is transported to the installation location.
1.
Remove the plastic band from the pallet and packaging and Pull the clamp off the packaging.
2. Lift up the cover and set the cardboard box with wall holder and accessories aside.
3. Set the unit with base and side sections upright.
4. Remove the upper side section and base from the unit.
»
If the unit is in the correct installation position: Proceed with the installation of the wall holder.
6.2
Installing the wall bracket
400mm*
500 mm
300 mm
550mm
400mm*
111mm
1
2
3
4
6
5
7
1150
600
250
400
**
**
8
1
Figure 11: Minimum clearances/mounting
Figure 12: Position of wall holder/ suspension
Key
1
Wall bracket
5
Screw for securing purposes (1x)
2
Fixings for mounting
6
Bracket to prevent unit displacement
3
Lock washer
7
Marking as installation aid
4
Screws for mounting (5x)
8
Seating recess
*
**
Recommended clearance: 400 mm / minimum clearance: 120 mm
recommended clearance: 550 mm / minimum clearance: 370 mm
Installing the wall bracket
ඣ
Cardboard box with wall holder and mounting kit removed from packaging and opened.
1.
Mark the suspension position with a line on the wall surface corresponding to the position of the wall holder
(Figure 12) .