26
PROCEDURE 18B - PERFORM MANUAL DIAGNOSTICS
Use the Diagnostic command code to perform manual diagnostics of the lock to verify
proper operations of the lock’s electronic circuit including the green LED, red LED, buzzer
and the twelve keypad/pushbuttons - 0 through 9, * and # keys.
Required User Level: Master, Manager
1. Put the lock into “LearnLok
TM
” Pushbutton Programming Mode ->
# Master PIN
(or Manager credential) #
2. Enter Command
500#
for Diagnostics.
3. You will see a green LED and hear a high beep, followed by a red LED and a low
beep to indicate that the LEDs and the buzzer’s circuits are working properly.
4. Enter
1234567890*#
, in that order exactly, to test each pushbutton’s electronic
circuit. If every pushbutton’s electronics is working correctly, you will see a green
LED and hear a normal beep for each pushbutton that is pressed; this indicates
successful test.
5. Example of Complete Entry:
500#1234567890*#
.
7. If you see a red LED at any time you are pressing a pushbutton, in Step 5 above,
or at the end of the sequence, there could be a problem with the pushbutton
electronics.
8. Try the Diagnostics again as show in Step 5 above.
Important:
If you still see the red LED and/or hear the low beep, the lock has a
problem. Contact Kaba’s technical support at 800-849-TECH(8324) Option 5
to help diagnose and fix the problem.
Note: The following proceedure applies to the E-Plex 37xx locks only:
PROCEDURE 19B - SWINGBOLT OPERATION
This operation is fairly similar to the Privacy function of a conventional lock with a physi-
cal deadbolt, but not quite! In the Swingbolt operation, any valid user can disengage, ie.,
override the “privacy” by entering a valid Credential and then turning the thumbturn
which will retract the swingbolt down. Now the lock will behave as though it is in a “latch
holdback” mode since the swingbolt is completely retracted and stays retracted, thus
allowing free access without any credentials. You perform the same sequence of opera-
tions to engage, ie., re-lock by bringing the swingbolt back to its “Home” (horizontal
locked) position.
•
Important: the swingbolt engage (project it) and disengage (retract it) actions are
strictly manual and are accomplished by flipping the thumbturn on the lock front
housing. This function is neither programmable nor automatic and so you must be
sure to manually re-lock if it was left in a retracted/open position.
•
any user with a valid Credential can perform this function – ie., engage or disengage
the swingbolt anytime.
•
when the swingbolt is disengaged (retracted), it will physically stay retracted down
when the door closes so that users carrying packages etc. do not have the incoven-
ience of having to turn the thumbturn again to open the door, but simply push the
door to enter without a credential.
•
from the interior side of the door, any person (valid user or not) can manually disen-
gage (retract) or engage (project) the swingbolt to unlock or lock the door.
Содержание EX3600
Страница 1: ...Operations Manual E Plex Card based 36xx 37xx 56xx 57xx lock series ...
Страница 38: ...36 Notes Notes ...
Страница 39: ...37 Notes Notes ...
