Kaba EX3600, Руководство по эксплуатации

Страница: 10 / 40

10
PROCEDURE 2A - MODIFy THE MASTER USER ACCESS PIN
Required User Level: Master
1. To change the factory default Master PIN, follow the next three steps:
2. Put lock into Pushbutton Programming Mode.
3. Use the command,
000,
to change the Master PIN, followed by the new Master PIN
itself.
4. You must use 8 digits between
00000000
and
99999999
as follows:
000#MMMMMMMM#
, we’ll use
000#87654321#
as an example.
5. Enter the Master PIN again
87654321#
for confirmation.
6. Example of Complete Entry:
000#87654321#87654321#
.
7. Key in another # to indicate the end of programming.
8. After that, you will always use your own Master PIN. Please write this PIN down and
keep in a safe place. From now on the factory default Master PIN is no longer valid.
Note: In the E-Plex LearnLok
TM
keypad programming and usage mode, the master’s
credential is PIN only and no card can be assigned to the Master .
PROCEDURE 3A - SET THE DATE / TIME
Note
: Not required if software is not used since you will not be able to audit lock without
the software.
You must enter the current date and time in each lock to enable accurate
programming and auditing. Always enter Standard Time; the software package (if and
when used) will make the adjustment for Daylight Savings Time and from then on will
switch the 1 hour spring/fall time automatically when the DST switch occurs every spring
and fall. Enter
001
for date settings and
002
for time settings. Date / time settings are
maintained even after a battery change unless you remove the batteries for more than
two minutes. If this happens, the time will be reset to 00:00:00 and the date to
01/01/2000 and you must rest the lock to the current date & time.
Required User Level: Master
1. Put lock into pushbutton programming mode.
2. Enter the date as follows:
001#MMDDyy#
(Month, Day, Year, where
MM
= 01 to
12;
DD
= 01 to 31;
yy
= 00 to 99. For example, Nov. 22, 2007 would be entered as
112207).
3. Enter the date again to confirm
MMDDyy#
. Example of Complete Entry:
001#112207#112207#
.
4. For the time, enter as follows:
002#HHMM#,
where HH = 00 to 23 hours; MM =
00 to 59 minutes. Use military time - for example eight-
thirty in the morning would be 0830, while in the evening it would be 2030).
5. Enter the code again
HHMM#,
for example
0830
.
6. Example of Complete Entry: 002#0830#0830# .
7. Enter another
#
to indicate the end of programming.
8. The current date and time are now programmed into the lock.