40
Mandatory Audit Events
Events
PIN Code Shown
Master’s combination modified
Modified Master User’s PIN code*
Manual Programming Mode
PIN code that was used to state the Manual
Programming Mode
M-Unit Communication started
PIN code that was used to start the
Communication Mode
Lock opened with valid access code
PIN code that was used to open the door
Manual Programming Mode ended
N/A
Audit report retrieved
N/A
M-Unit Communication ended
N/A
M-Unit Communication ended
N/A
Key override usage detected
N/A
Hard reset
N/A
Set date
N/A
Set time
N/A
Save old date/time (1)
N/A
Invalid Code (2)
Invalid PIN code
Shutdown Time period
Last invalid PIN code
Tamper Shutdown Time period ended
N/A
Lock Shutdown at low voltage
N/A
Battery connected
N/A
Low battery warning started
N/A
Deadbolt engaged
N/A
Deadbolt retracted
N/A
Remote Unlock Open
N/A
*Master and M-Unit PIN codes are not shown in audits for security reasons.
(1) In an audit sequence, this transaction will always precede “Set Date” and “Set Time” audit event. This enables
the person reading the audit to know if there was a time lapse (e.g. When it took more than 2 minutes to replace
batteries) between the original date/time and the new date/time that was set.
(2) This transaction is during Tamper Shutdown time following the configured maximum number of invalid codes
entered. Each time an invalid code is keyed in during this period, the Shutdown Time is restarted, so that an
invalid user can never gain access to the lock entering a series of invalid codes until he hits the right one.
Audit Event
Optional Audit Filters
