PELLET BURNING STOVES INSTALLATION & MAINTENANCE MANUAL
4
• Any liability for misuse of the product is solely responsible and design raises K-Stove from all civil and criminal
responsibility ;
• Any type of unauthorized tampering or substitution of non-original parts of the stove can be dangerous to the operator
safety and lifts K-Stove DESIGN from all civil and criminal.
• Most of the surfaces are very hot (door, door handle , front door glass, flue pipes, etc..). It is therefore necessary to
avoid contact with these parts without adequate protective clothing or special thermal protection , such as gloves and
thermal protection systems devices such as “ cold hands", not supplied with this oven and complete responsibility and
discretion of the end user .
• Explain carefully the danger to the elderly, disabled and particularly children, keeping them away from the stove
during operation.
• It is 'forbidden’ to operate the stove with the door open or with broken glass.
• Do not touch the stove with wet hands, being an electrical appliance. Always remove the power cord before opening.
• Before performing any cleaning or maintenance work make sure , in advance , to disconnect the heater from the
mains by unplugging the power cable.
• In case of fire in the chimney, turn off the stove, please disconnect from the network and never open
the door. Then call the appropriate authorities.
• The stove must be electrically connected to a network with grounded discharge facility.
• The stove must be connected to an electrical network appropriately sized to the electric power of the
stove.
• Incorrect installation or poor maintenance (non-conforming to the information in this booklet) can
cause damage to persons, animals or things. In this case K-Stove DESIGN is relieved of any civil or
criminal liability.
1.2. OPERATING INSTRUCTIONS
• Turn off the heater in case of
failure or malfunction.
• NEVER manually load the pellet into the burner.
• The accumulation of unburned pellets in the burner after repeated "misfire" must be removed before
proceeding with a new ignition.
• Do not wash the inside of the stove with water.
• Do not wash the stove with water. Water may enter the unit and damage the electrical iinstallation,
causing electric shock.
• Do not expose your body to hot air for a long time. Do not overheat the room where you are
staying and where the stove is installed. This can damage the physical condition and cause health
problems.
• Do not expose to direct the flow of hot air plants or animals. It could have harmful effects on
plants or animals.
• Do not use other fuel other than EN-A1-Plus
Certified – wood pellets .
• Install the stove in a suitable location which has available all necessary facilities required such as
fire prevention facilities and all necessary utilities are available such as – but not limited - power
supplies (air and electric) and exhaust fume, in conformity with the provisions in force.
• The storage of the stove and the ceramic coating must be stored in a dry and humidity free premises.
•
It is recommended to place the stove directly on the floor , and whereas this floor is made of flammable materials ,
in this case it is required to isolate properly.
