JVC KW-M450BT, Инструкция по эксплуатации

Страница: 39 / 56

37 ENGLISH
<Clock>
Select the method to set the date and clock. For
details, see “Calendar/clock settings” on page 5.
<Time Zone> *
Select the time zone for your area. For details, see
“Calendar/clock settings” on page 5.
* Selectable when [Clock] is set to [Manual]. (Page 5)
<Clock Adjust> *
Adjust the date and clock manually. For details, see
“Calendar/clock settings” on page 5.
* Selectable when [Clock] is set to [Manual]. (Page 5)
<DISP Key>
Select the screen displayed when [ ] on the
pop-up short-cut menu is touched, when DISP button
on the remote control is pressed, or when DISP button
on the steering wheel remote controller is pressed.
•
Apps : Displays the Mirroring for JVC application
screen from the connected smartphone.
• NAV *: Switches to the navigation screen from the
connected navigation unit.
– Navigation screen cannot be displayed if
<Navigation Input> is set to [OFF] . (Page 40)
• OFF (Initial): Displays the current source control
screen.
* Not available for KW-M450BT Australia and New Zealand models/
KW-M450BT Indonesian models.
Settings Settings
<Beep> *
• ON (Initial): Activates the key-touch tone.
• OFF : Deactivates the key-touch tone.
* Available only when <X'over Network> is set to [2way].
(Page 30)
<Language select>
Select the text language used for on-screen
information. For details, see “Initial settings” on
page 4.
<Touch Panel Adjust>
Adjust the touch positions of the keys on the screen.
Touch and hold the center of the marks at the lower
left (
1
), then the upper right (
2
) as instructed.
(Hold)
(Hold)
• To reset the touch position, touch [Reset] .
• To cancel the current operation, touch [Cancel] .
4
Touch [Learning completed] to finish the
procedure.
To change the previously assigned function:
1
Touch the key to change on the <Steering
Remote Controller Setting> screen.
2
Select a new function to assign from the pop-up
list.
3
Touch [Change completed] to finish the
procedure.
To initialize the setting:
Touch [Learning initialization] .
• A confirmation message appears. Touch [Yes] .
– To cancel the initialization, touch [No] .
Note:
• Touching [ ] key without touching [Learning
completed] or [Change completed] will not assign
the functions selected in the previous steps.
• Be sure to touch [Learning completed] or [Change
completed] to assign the functions.
04_KW_M450BT_M_Body02.indd 37 04_KW_M450BT_M_Body02.indd 37 10/4/2019 1:46:06 PM 10/4/2019 1:46:06 PM