1-24 (No.HC034<Rev.001>)
(3) [PIXEL COMPEN EXECUTING] is displayed and the de-
tection required for white blemish correction automatically
starts.
At this time, the camera lens is closed and the mode
changes to the SLOW SHUTTER mode.
(4) When the white blemish detection completes, the result
data is stored in the CPU memory, and an end message is
displayed as shown below. Turn OFF the power.
(After completing white blemish detection, the "Camera
Resolution" and "Frame & Bit Rate" settings return to the
original settings.)
(5) If any errors occur during the detection, an error message
is displayed, then the screen returns to the MENU display.
5.1.5.1.1
Details on correctable white blemish
Up to 127 errors with composite video levels of 50mV or more
can be corrected. No limitation of errors per line within 127. How-
ever, the maximum consecutive errors are four and the correc-
tion results may be inferior to the single error correction.
Oblique noise may be observed on the screen during the white
blemish detection. This is due to the principles of error correction
and is not a malfunction.
White blemish can be detected in the following area.
5.1.5.1.2
SDI OUT Menu operation
(1) Open the ADVANCED FUNCTION Menu, move the cursor
to [SDI OUT], and then press the [Set] button or the [Cross-
Shaped] button (right).
(2) The SDI OUT Menu is displayed.
Refer to 5.1.5 ADVANCED FUNCTION Menu because the oper-
ations are almost the same.
(Bold is the factory setting.)
5.1.6 SERVICE FUNCTION Menu Operation
(1) Refer to 5.1.2.3 to display the SERVICE MENU.
(2) Move the cursor to [SERVICE FUNCTION], then press the
[Set] button or the [Cross-Shaped] button (right).
(3) The SERVICE FUNCTION Menu is displayed.
Message
Error details
Operation
LENS NOT
CLOSED?
The lens does not close
for detection.
No result is stored in the
EEPROM.
COUNT
OVER
The number exceeds
the specified count.
Only the specified
count of data is stored
in the EEPROM.
PIXEL COMPEN
EXECUTING
PIXEL COMPEN
END
TURN POWER OFF
AND ON AGAIN
100%
100%
Item
Parameter
OUT
TYPE CONSUMER Adds the AES/EBU consumer
channel status bits.
PRO
Adds the AES/EBU Professional
channel status bits.
LTC
OFF
Does not add the LTC data on SDI
output.
ON
Adds the LTC data on SDI output.
VITC
OFF
Does not add the VITC data on SDI
output.
ON
Adds the VITC data on SDI output.
AUDIO+TC OFF
Does not add the audio data and TC
data on SDI output.
ON
Adds the audio data and TC data on
SDI output.
--- SDI OUT ---
OUT TYPE
PRO
LTC ON
VITC ON
AUDIO+TC ON
BACK
--- SERVICE FUNCTION ---
PIXEL COMPEN
ON
TEST SIGNAL GEN.
OFF
SIG. OXYGEN
AE TEST R
SIG. FLUORINE
Y RAMP
SIG. NEON
Y RAMP
RM DC DISP
OFF
ANTON SHUT DOWN 12.8V
ANTON ALARM
13.4V
IDX SHUT DOWN
12.5V
IDX ALARM
13.4V