JVC GY-HM750U, Инструкция по эксплуатации

Страница: 128 / 141

122
Connecting External Devices
“Backup recording” can be performed, which allows the
same image recorded to the SDHC card on the camera
recorder to be recorded to the external device connected to
the IEEE1
3 94 terminal. ( A Page 122)
Note :
● When connecting the camera recorder to an external
device using an IEEE1
3 94 cable, make sure to observe
the following. Improper connection may cause the circuit
of the connected unit to malfunction.
● Turn off the power of the camera recorder and
connected devices before connecting the IEEE1
3 94
cable.
● Do not connect the cable in an environment where
static electricity occurs or is likely to occur.
● Make sure that each camera recorder is connected to
only one external device at any one time.
● When the video format input from the [IEEE1 3 94] terminal
is different from the video format of the camera recorder, a
A VIDEO FORMAT INCORRECT B message is displayed.
Set according to the video format entered for [System
Definition], [Camera Resolution], and [Frame & Bit Rate]
in the [Record Format] menu. (
A Page 75)
● If the [INT/EXT] IEEE1 3 94 interface terminal switch is set
at
A
EXT
B
and the
A
HQ
B
mode is selected in [Frame & Bit
Rate], signals will not be output from the [IEEE1 3 94]
terminal. ( A Page 75)
Backup Recording
When the camera recorder is set to Camera mode, images
shot using it can be stream output from the IEEE1
3 94
terminal.
According to the recording operation on the camera recorder,
recording to the camera recorder and external device may be
performed synchronously or separately.
1
Connect the camera recorder to the backup device.
Connect the camera recorder to the backup device using an
IEEE1
3 94 cable, using the camera recorder as the master
device.
2
Set the camera recorder to Camera mode.
3
Set the recording video format.
Perform setting in the [Record Format] menu. Select a video
format in [System Definition]. (
A Page 75)
Note :
● To back up in the HDV format, be sure to select SP mode
for the [Frame & Bit Rate] setting.
4
Perform the following settings on the camera recorder
(master device).
A
Set the [INT/EXT] IEEE1 3 94 interface terminal switch to
A EXT B .
B
Switch to Camera mode.
C
Specify how recording to the camera recorder and
external device is to be performed with the recording
operation on the camera recorder using [1
3 94 Rec
Trigger] in the [Others] menu. ( A Page 94)
IEEE1 3 94 Connection
[IEEE1 3 94] Terminal
VIDEO FORMAT
INCORRECT
[HD (MPEG2)] : Performs backup in the HDV format.
[SD (DV)]
: Performs backup in the DV format.
Camera recorder
(Master Device)
Backup Device
IEEE1 3 94
Cable
Signal Flow
[IEEE1 3 94]
Terminal
[INT/EXT] IEEE1 3 94
Interface Terminal
Switch