Filename [DR-MV1SE_04Name.fm]
Masterpage:Left0
16
EN
Page 16
March 11, 2004 7:27 pm
INSTALLING YOUR NEW UNIT
It’s essential that your unit be properly connected.
1
Make sure the package contains all of the accessories listed in
“SPECIFICATIONS” on page 95.
2
Place the unit on a stable, horizontal surface.
3
Connect the unit to a TV depending on the TV and cables you
use.
Basic Connection
8
To connect to a TV with AV input connectors —
A
Disconnect the TV aerial cable from the TV.
B
Connect the TV aerial cable to the ANTENNA IN connector on
the rear panel of the unit.
C
Connect the ANTENNA OUT connector on the rear panel of the
unit and the TV’s aerial connector with the provided RF cable.
D
Connect the L-1 IN/OUT connector on the rear panel of the unit
and the TV’s 21-pin SCART connector with a provided 21-pin
SCART cable.
●
The L-1 IN/OUT connector accepts and delivers either a composite
signal (regular video signal), Y/C signal or RGB signal.
●
Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to
the type of your TV’s SCART connector.
8
Component Video Connection (DVD deck only)
To connect to TV’s component video input connectors
A
Perform
A
–
C
in “Basic Connection”.
B
Connect the unit’s COMPONENT VIDEO OUT connectors to
the TV’s component video input connectors.
C
Connect the unit’s AUDIO OUT connectors to the TV’s AUDIO
input connectors.
●
You can obtain high-quality component video pictures.
●
If your TV is not stereo-capable, use the unit’s AUDIO OUT
connectors to connect to an audio amplifier for Hi-Fi stereo sound
reproduction.
●
By using the component video connection, you can view the images
in the progressive mode. For switching to the progressive mode, refer
to “Scan Mode Set” (
墌
pg. 88).
NOTE:
Select an appropriate option of “L-1 OUTPUT” as follows (
墌
pg. 72):
4
Plug the end of the AC power cord into an AC outlet.
●
“LOADING” blinks on the front display panel when the AC plug of the
power cord is connected into a mains outlet and it takes
approximately 50 seconds for the unit to be turned on. This is not a
malfunction.
Basic Connection
ATTENTION:
Your TV must have a 21-pin AV input connector (SCART) for the
connection to the unit.
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO
OPERATION CAN BE PERFORMED.
2
RF cable
(provided)
Back of unit
Back of TV
TV aerial cable
21-pin SCART connector
21-pin SCART cable
(provided)
Mains power cord
ANTENNA IN
L-1 IN/OUT
ANTENNA OUT
Mains outlet
Aerial connector
When your TV’s SCART
connector accepts:
Set “L-1 OUTPUT” to:
Composite signals
“SCART VIDEO”
Y/C signal (separated
luminance (brightness) and
chrominance (colour) signals)
“SCART S-VIDEO”
RGB signal
“SCART RGB”
Component video signal
“COMPONENT”
After connection is completed, perform “Auto Set Up” on
page 17.
DR-MV1SE_00.book Page 16 Thursday, March 11, 2004 7:28 PM
Содержание DR-MV1
Страница 101: ...EN 101 Memo ...
Страница 102: ...102 EN Memo ...
Страница 103: ...EN 103 Memo ...
Страница 104: ...DR MV1 COPYRIGHT 2004 VICTOR COMPANY OF JAPAN LTD E 104 EN EN Printed in Beijing 0304MNH ID BJ ...