Masterpage:Right0
Filename [DR-M1EK_10Editing.fm]
Page 87
August 15, 2003 7:53 pm
87
REMOTE CONTROL
Remote Control
Functions
Remote 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four
codes (1, 2, 3 or 4). The remote control is preset to send 1 code
signals because your unit is initially set to respond to 1 code
signals. You can easily modify your unit to respond to 2, 3 or 4
code signals.
On the remote control
Keep pressing
SET UP
down during steps
A
–
B
.
A
Change the remote control code.
Press the
number key “1”
for 1,
“2”
for 2,
“3”
for 3 or
“4”
for 4.
B
Set the remote control code.
Press
ENTER
to set the code.
On the unit
C
Turn off the unit.
Press
1
on the unit.
D
Display the code.
Press
4
on the unit for over 5 seconds while the unit is
turned off.
●
The code currently set appears on the front display panel.
E
Change the unit’s code.
Press
8
on the remote control.
●
The code currently set on the remote control blinks on the
front display panel for approximately 5 seconds, and is
applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (
墌
pg. 95), it is not
possible to change the remote code.
Slide the
TV/CABLE/SAT/DVD
switch to
DVD
.
DR-M1EK_01.book Page 87 Friday, August 15, 2003 7:53 PM
