Filename [DR-M1EK_11Subsidiary.fm]
Masterpage:Left+
Page 110
August 15, 2003 7:53 pm
TROUBLESHOOTING (cont.)
110
RECORDING
INITIALIZING
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
1. The desired programme cannot be
recorded.
●
The channel position does not
correspond to that in the receiving area.
Set the correct channel position for the
receiving broadcast. (
墌
pg. 98)
2. Recording cannot be made.
●
No disc or a disc not being compatible
with the unit is loaded.
Load a recordable disc on the unit.
(
墌
pg. 6)
●
The disc loaded is not formatted.
Format the disc. (
墌
pg. 106)
●
A finalised DVD-R disc is loaded.
Recording cannot be made on finalised
discs. (
墌
pg. 107) Load a recordable disc
on the unit.
●
The disc is full or does not have enough
space for the programme to be recorded.
Clear unnecessary programmes on the
disc or load a blank disc. (
墌
pg. 71)
3. Timer programming cannot be made.
●
Date and time is not correct.
Set date and time correctly. (
墌
pg. 104)
4. Timer programming recording does not
start.
●
Power failure occurred before the timer
programmed recording starts.
Check the timer programming. (
墌
pg. 63)
5. VIDEO Plus+ Timer Programming
cannot be made.
●
Date and time set on the unit is not
correct.
Set date and time correctly. (
墌
pg. 104)
●
The channel position does not
correspond to that in the receiving area.
Set the correct channel position for the
receiving broadcast. (
墌
pg. 98)
6. Automatic Satellite Programming
recording does not start.
●
The satellite receiver is not connected
properly to this unit.
Connect the satellite receiver to the L-2
IN/DECODER connector properly.
(
墌
pg. 90)
7. On the front display panel, “– –:– –”
appears.
●
Power failure occurred.
Set date and time correctly. (
墌
pg. 104)
8. “PROGRAM FULL” appears on the TV
screen during timer programming.
●
Eight programmes have already been
timer programmed.
Clear unnecessary programmes on the
unit, then try timer programming again.
(
墌
pg. 63)
9. The disc space does not increase when
recorded programmes are cleared.
●
The PC’s data recorded on a DVD-RAM
drive cannot be cleared on this unit.
Format the disc. (When the disc is soiled,
wipe the disc with a soft dry cloth before
formatting.) (
墌
pg. 10, 106)
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
1. Malfunction occurs on the unit.
—
Press
1
to turn off the unit, press and
hold
1
, then press
8
for two seconds or
more.
ATTENTION:
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc,
operate the unit as usual.
DR-M1EK_01.book Page 110 Friday, August 15, 2003 7:53 PM
